Electrolux Icon E32AR85PQS Guide de l'utilisateur télécharger pdf (Page 7)

7

Installing Door Handle

Door Handle

Mounting Instructions

1. Remove handle from carton and any

other protective packaging.

2. Position handle end caps over upper

and lower preinstalled shoulder bolts

(A) that are fastened into door.

3. While holding handle ﬁrmly against

door, fasten upper and lower Allen set

screws (B) with supplied Allen wrench.

NOTE

All set screws should be tightened so the

screw is below the surface of the handle.

The handles should be drawn tight to

freezer and refrigerator doors with no gaps.

Opening the opposite door while tightening

the Allen screw makes installation easier.

The door handle may loosen over time or if

it was installed improperly. If this happens,

tighten the set screws on the handles.

Toe Grille Removal

To remove the toe grille, use a Phillips

head screwdriver and remove the 2

screws holding the toe grille to the cabinet.

Then pull the toe grille away from the unit.

Leveling

• The refrigerator must have all bottom

corners resting ﬁrmly on a solid ﬂoor.

• The ﬂoor must be strong enough to

support a fully loaded refrigerator.

• It is VERY IMPORTANT for your

refrigerator to be level in order to

function properly. If the refrigerator

is not leveled during installation,

the door may be misaligned and

not close or seal properly, causing

cooling, frost or moisture problems.

Remove

Screws

Toe Grille

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Commentaires sur ces manuels

Pas de commentaire